HACH SC100 MANUAL PDF

View and Download Hach Sc E instrument manual online. Analysis System. Sc E Measuring Instruments pdf manual download. Hach Sc Controller User Manual – Download as PDF File .pdf), Text File .txt) or read online. Hach Sc Controller User Manual . Hach Company, – .. 37 W with 25 W sensor/network card load 24 VDCpowered sc model: 24 VDC.

Index Numerics 90 Degree Detector Page 43 Section 6 Replacement Parts 6. The barrier must remain in place unless a by qualified technical personnel qualified installation technician is installing wiring for power, alarms, or relays.

Mounting The Controller Installation 3.

Page 34 Operation 4. The data logs store the measurement data at selected intervals. Tug gently to check the connection. Drain body and clean the body and bubble trap.

Figure 1 Components of a Basic System 1 5 2 4 6 sc 3 7 8 9 10 1.

The passcode is factory set to sc the five digits must be followed by a space to remove the trailing asterisk. The controller contains three relays designed for use with high voltage Danger: The controller display shows the current reading plus a secondary measurement such as temperature if connected to a single sensor, or two readings with their corresponding secondary measurement readings when two sensors are connected.

Page 71 Index Sample Line Installation Depends on sample Clean the sensor characteristics. Failed fuses are an indication that an equipment problem could exist. Measured reading based on a gain of 1. Page 58 Index Dry Verification System Startup Two types of verifications are offered.

Calibrate Sensor as required by regulatory agency Per agency-dictated schedule. Page of 72 Go. Or point us to the URL where the manual is located. Section 7 Warranty, liability and complaints HACH LANGE GmbH warrants that the product supplied is free of material and manufacturing defects and undertakes the obligation to repair or replace any defective parts at zero cost. Pan head screw, M6 x 1,0 x mm 4Cat.

Customize sc010 outputs using the table in section 4. The keypad consists of the eight keys described in Table 7.

The warranty period for instruments is 24 months. Section 1 Specifications Specifications are subject to change without notice. Page 37 Operation 4.

What’s missing? Tell us about it.

Tell us about it. Problem resolution and fuse replacement should only be performed by qualified service personnel. Page 46 Warranty, liability and complaints 7.

Wire as shown in Table 5.

Wear cotton gloves to protect your hands and to scc100 fingerprints on the bulb. Pull the lamp leads and connector through the hole in the lamp housing.

Hach-Lange SC User Manual | 58 pages

Pipe vertical or horizontal 5. Table of Contents Section 1 Specifications Supplied mounting hardware is shown in Figure 6, Figure 7, and Figure 8. Table of Contents Add to my manuals Add. The display will flash on startup, when a sensor error has occurred, when the hold outputs function has been activated, and when a sensor is being calibrated.

DANGER Do not replace any component unless power to all electrical circuits to the Controller have been switched off and the area is known to be non-hazardous. Page 35 Operation During calibration, analog outputs can remain active, held, or transferred to a preset mA value. Turbidimeter Installation Information Installation 3.

To locate the representative nearest mxnual, send e-mail to intl hach.

HACH SC E INSTRUMENT MANUAL Pdf Download.

Section 4 Operation Section 4 Operation 4. Page 33 Operation 4. Bracket, pipe mounting, Cat.

In the United States: Section 10 Repair Service Authorization must be obtained from Hach Company before sending any items for repair.